The most compact overhead lamp in the range. Digital intensity display and a low-temperature body that saves power and extends LED life. An optional remote control allows adjustment from floor level, with no ladder work mid-inspection.

Built to grow from one head into a full inspection canopy. Series power-supply connection lets multiple lamps run from a single supply. An active cooling fan module is available to hold output steady through continuous long-hour runs.

Coverage that grows with the part. Slave units dock to the main unit on the short side. A rugged aluminium body with passive fanless cooling operates at 30–50 °C, and at just 6 cm deep, this is the slimmest overhead lamp in the range.

The lightest lamp PROMAG makes, and the only flashlight certified to all three aerospace standards together. Full brightness the instant it is switched on, with no warm-up — built for MRO and flight-critical component inspection.

The highest certified output in the PROMAG range. Focused into a tight beam for small welds and awkward geometry. Anodised aluminium body with an antioxidant filter that keeps UV-A output stable over the life of the lamp.

Four high-output UV-A LEDs with a high/low intensity change-over switch. Battery gauge, three-position switch and natural air cooling. Runs on a 12 V Li-ion pack or straight off mains, with white-light versions available.

The same body as VICTORY Ⅰ, sealed and silenced. IP64 against dust and splash, and fanless mechanical cooling with no moving parts to fail. Battery runtime doubles to three hours continuous.

Frees both hands for component handling. The rear-mounted battery balances the weight and keeps cables clear of the work, the head tilts through 90°, and it wears directly on the head or clips to a safety helmet. Two batteries ship as standard.